Back to Fillers

Add to Wish List

Available Sizes

Available at**

*Actual colours may differ from screen representation.
**Not all stores range all sizes and products. Please check with the stores.

Selleys Plasti-Bond Builder

Selleys Plasti-Bond Builder is an easy to sand building filler for use repairing damage to wood and most other common building materials.

Features

Excellent adhesion to a wide variety of surfaces
Easy to sand
Sets hard in just 20 mins
When dry it can be sawn, drilled, sanded and painted
Can be coloured with powdered (builder's) oxides or paint tinters before hardener is added
White in colour

Repairing damage to a wide range of materials including timber, fibro, concrete, bricks, metal, alloy, fibre glass, tiles
Product will not adhere to Polyethylene, Polypropylene and Teflon

Surface to be repaired should be clean, dry and free from paint, grease or oil.
Stir Plasti-Bond before use. Add 2.5cm of hardener to every 20mL (heaped teaspoon) of Plasti-Bond.
Mix together thoroughly until hardener is evenly dispersed and a uniform colour is achieved. Working time varies between 3-8 minutes depending on temperature. For faster cure, or in cold weather, use more hardener.
Apply with a putty knife, slightly overfilling to allow for sanding.
Any excess can be smoothed off easily with a surform file or fine plane before product is rock hard (between 20 to 30 minutes). Ordinary files or sandpaper may be used once rock hard (after about 30 minutes). Feather edges for a perfect finish.
Paint with water or oil based paints.
Clean tools with mineral turps before product cures.
Replace lid after use. Store in a cool place.

Product requires a hardener to be added and stirred
Once hardener is added, use product immediately
When repairing leave dents slightly overfilled to enable sanding
Where a faster setting time is required, add more hardener
When colouring Plasti-Bond, mix the colour into the resin BEFORE adding the hardener as thorough mixing is required and sufficient mixing may not be achieved before the product sets if added after the catalyst.
When colouring Plasti-Bond mix the colour with the total required amount of base for the whole job even if later used in smaller lots as this will result in a uniform colour. Matching the colour again can be difficult.
The hardener is a catalyst and will work in even small amounts. Sufficient hardener is included to cure at least the entire kit. Add only the recommended amounts of hardener. If too much is used then you may run out of hardener before activating the entire kit.
When using a whole kit at once measure the catalyst out carefully as excess hardener is often provided in the kit.
Product heats up significantly and sets faster when used in large quantites. When mixing a whole larger kit ensure that this heat is taken into account when choosing materials, working times, application methods and containers.

Avoid contact with eyes and skin. Avoid breathing vapour. Use only in ventilated areas.
Product is flammable so do not use near a flame, fire or spark producing apparatus or machinery
If poisoning occurs contact doctor or Posions Information Centre. If swallowed, do not induce vomiting. Give a glass of water
For further detail on the safe use of this product, please refer to the Material Safety Data Sheet, which can be downloaded from this site.