Selleys The One


Selleys THE ONE Adhesive delivers superior bond strength on any building surface. Can be applied to wet or dry, interior or exterior, porous or non porous surfaces*. Extreme versatility that takes the guess work out of DIY.


  • Strong bond on any building material
  • Can be applied to wet or dry surfaces
  • Suitable for interior and exterior applications
  • Can be used on porous and non-porous materials
  • Will adhere to oily surfaces
  • Low VOC
  • Excellent weather resistance
  • Flexible and long lasting
  • Paintable with water-based paints

Available Sizes

  • 290g Cartridge


  • Grey

Available at

  • Bunnings
  • Mitre 10

Contact the store to confirm stock availability, as some stores may have a limited range.

What materials is this product suitable for?

  • Suitable for all building materials*

How to use this product

  1. Ensure surfaces are clean and free from grease or loose particles.
  2. Cut tip of cartridge, fit nozzle and cut at 45ºangle to desired size before placing in a cartridge gun such as Selleys Light Speed Caulking Gun.
  3. Apply with a caulking gun, pushing adhesive onto the surface.
  4. Position pieces and press firmly together. Larger, heavier materials may need to be supported until the adhesive cures.
  5. If painting, paint with water-based paint.

Handy tips

  • Keep a pack of SELLEYS Sugar Soap Wipes handy to wipe up any spills and for cleaning. They are an easy and effective way to keep clean on the job.


  • *Not for PE, PP, PTFE, or permanent water immersion

Clean up

  • Clean up with turps before the adhesive cures.

Safety tips

  • Keep out of reach of children.
  • Avoid skin and eye contact and breathing vapours.
  • Use in a well ventilated area.
  • Wear protective clothing, gloves and eye protection.
  • If on skin, wash with soap and water.
  • Cure product before disposal.
  • Product releases methanol during cure.

Storage and re-use

  • Store in a cool place.
  • The adhesive should be used within 6 months after opening.
  • If the adhesive is going to be used again within a few days, leave the nozzle on and merely extrude approximately 2 cm of product before storing the cartridge upright. This will cure to a plug which can easily be pulled out when required.
  • For longer storage periods, leave the nozzle on and place a piece of plasticene or Blu Tack over the end of the nozzle. Tightly tape a piece of aluminium foil over the whole nozzle to exclude any air.
  • When you want to re-use the product, simply take off the foil and plug from the old nozzle pull out the excess adhesive from the nozzle with a corkscrew, then re-pierce any cure at the tip of the cartridge and re-use.
  • If cure has taken place into the cartridge, the product is unlikely to be in a useable state and should be desposed.