Selleys Space Invader is a non-toxic expanding foam filler that is safe and easy to use, and cleans up with water. It is specially formulated for filling large cracks, gaps and voids and will not over expand like traditional polyurethane foams. 

Features

  • Non toxic- safe and easy to use
  • Can be cleaned up with water
  • No over expansion
  • Free of hazardous Isocyanate
  • Cured expanded foam can be easily compressed back into cavity
  • Easy reusable dispenser valve (just rinse with warm water)
  • Paintable with acrylic paints

Where can this product be used?

  • Sealing and filling around:
  • Window frames
  • Door frames
  • Behind skirting boards and architraves
  • Ducts, pipes, vents and other gaps and spaces

What materials is this product suitable for?

  • Wood
  • Plaster
  • Metal
  • Plastic*
  • Most common building materials
  • *Not for polyethylene, polypropylene or teflon

Please contact your store to confirm avaliability, as some stores may have a limited range.

Size 320g Aerosol can
Colours Off White
Technology Water Based
Use Interior
   

Always wear eye protection and use in ventilated area. Product is flammable during dispensing- extinguish all ignition sources during use and cure.

  1. Ensure area is clean and free from grease, dirt and dust.
  2. Screw nozzle onto valve on can
  3. Hold can upside down. Shake can vigorously for 30-45 seconds and until you can hear the ball inside move.
  4. Activate trigger to dispense foam. For holes and gaps greater than 5cm deep, fill to a depth of at least 5cm. Confined or large spaces are best filled in layers of 4-5 cm deep, allowing each layer to fully cure before applying the next.
  5. During use, stop frequently to shake and tap can vigorously to move product in can closer to dispensing valve.
  6. Fill the space or void to about flush with the surface.
  7. Foam can be tooled and remove excess while wet. Clean up spills immediately with wet cloth. Unscrew straw from nozzle and clean both with warm water.

        Limitations:

  • Not for areas in prolonged contact with water. Protect from water while curing and until sealed over with quality paint.
  • Not recommended for closed cavities.
  • Do not apply below 10°C.
  • *Not for polyethylene, polypropylene or teflon 
  • Application temperature 10°C to 35°C.
  • Cured foam becomes firmer with time.
  • Harder cured foam can be achieved by using a hair dryer to blow warm air (low speed) onto the foam while curing for a few minutes.
  • After curing, minor expansion can be compressed into the gap and if required foam can be plastered over with Spakfilla Rapid and painted with water-based paint.
  • For exterior applications, foam must be completely sealed with quality exterior acrylic paint after curing.
  • Clean up excess foam or spills with water before it dries.
  • Excess cured foam can be removed mechanically by cutting or scraping off. 

Related Products

Selleys No More Big Gaps

Selleys No More Big Gaps is an expanding foam, which cures into a semi rigid closed cell foam, making it ideal for filling large and irregular holes or cavities such as around pipes.

Selleys Space Invader Duty

Selleys Space Invader is a non-toxic expanding foam filler that is safe and easy to use, and cleans up with water. It is specially formulated for filling large cracks, gaps and voids and will not over expand like traditional polyurethane foams.


How to Guides