Selleys ArmourFlex provides superior strength with instant grab and more flexibility than conventional adhesive/sealants.

Features

  • Superior strength & instant grab
  • No primer required
  • Water tight seal with a 10 year guarantee*
  • Can be applied to wet or damp surfaces with excellent adhesion
  • Non-bubbling
  • Better curing and extrudability (>5°C)
  • Easily paintable with 2 coats of water-based paints after product skins in 60 to 90 minutes
  • Sandable
  • Low VOC**
  • Long lasting flexibility
  • Fast curing
  • No slump
  • Trafficable
  • Potable water approved AS/NZS4020 (Area to volume ratios
  • **Meets GBCA limits for general purpose and architectural sealants.

Where can this product be used?

  • Sky lights
  • Walls
  • Patios
  • Floors
  • Fencing
  • Windows
  • Expanding joints in concrete

What materials is this product suitable for?

  • Concrete
  • Timber
  • Metals
  • Cement sheeting
  • Brick
  • Plasterboard
  • Ceramic tiles
  • Fibreglass
  • Most plastics (Pre-test before use. Not for polyethylene, polypropylene or Teflon.)

Please contact your store to confirm avaliability, as some stores may have a limited range.

Size 300g cartridge
  465g cartridge
  600ml sausage
Colours 300g Cartridge-clear
  465g Cartridge - Grey, White and Clear
  600ml Sausage - Grey and White
Technology Sil-X®
Use  Interior 
  Exterior 
  1. Ensure substrates are clean and free of oil, grease or loose particles.
  2. Cut seal and nozzle and fit to cartridge, then place in caulking gun.
  3. Hold caulking gun at 45° angle and gun sealant ahead of nozzle ensuring product is pushed into joint.
  4. For neat joints, use masking tape on both sides of the joint and remove before skinning.
  5. Tool with a soapy solution before skinning occurs.

For optimal joint design, use non-absorbent backing material (e.g. polyethylene backer rod) and appropriate joint width/depth. See technical data sheet for more information. 

        Limitations:

  • Not suitable on polyethylene, polypropylene or Teflon.  
  • Not for permanent water immersion or below water-line use. 
  • In dry conditions, surfaces can be misted with water to speed up cure.
  • Paint with water-based paint. A minimum of two coats are necessary to ensure proper wetting out the sealant surface

 

* Refer to product label for full conditions. This guarantee does not limit and may not necessarily exceed your rights under the Competition and Consumer Act 2010. 

  • Uncured product can be removed with mineral turps.
  • Cured product can be removed with Selleys Silicone Remover or by mechanical action.

 


Related Products

Selleys ArmourFlex

Selleys ArmourFlex provides superior strength with instant grab and more flexibility than conventional adhesive/sealants.


How to Guides