DIY Lazy Susan

Beginner Intermediate Advanced

5 Hours

What You Need

Materials

75mm Lazy Susan Bearing Plate (90kg capacity)
A base (a tea pot stand will do the trick)
Selleys Araldite 5 min epoxy
A tray (alternatively a wooden chopping board or large coaster)
Paint- water-based varnish or self-adhesive vinyl

How To

First up- prepare your tray (if required) by sanding and sealed with some water- based varnish or paint if you wish
Once dry, turn over and mark the centre of your tray as well as the top of the base
Snap out the reusable cap from the Selleys Araldite 5 min syringe and dispense equal parts of both liquids into a small disposable container and mix them together thoroughly with a paddle pop stick
Mix in small portions, as the epoxy sets quickly (normally within 5 minutes)
Pop reusable cap from plunger back onto nozzle for storage
Apply the adhesive to the bottom of the bearing plate and secure to the base.
Then apply the adhesive to the top of the bearing plate and place the board on top.
Hold joins in place using tape or weights and allow to dry for min. 16 hours

Products

Selleys Araldite 5 Minute

Selleys Araldite 5 Minute epoxy adhesive is a clear, fast setting, two part epoxy which holds up to 75kg per cm2*

Selleys Araldite 90 Seconds

Selleys Araldite 90 Seconds epoxy adhesive is a 90 second setting, two part epoxy adhesive which enables a durable bond to a variety of surfaces without lengthy clamp times.