3 in 1 Adhesive, Sealant and Gap filler

        Adhesive

1. Apply to one surface, in beads for broad surfaces (every 30cm) or dots for small surfaces. Press surfaces together and allow to cure.

        Sealant

1. Apply product, ensuring it is forced into the joint, with good contact to surfaces. Tool with a soap solution before skinning occurs.

        Gap Filler

1. Apply product into gap. Smooth off with spatula dipped in soapy water. Allow to skin before painting with water based paints.

        Limitations:

• Not recommended for solvent based paints. If required, paint with a water based paint first. 

• For neater joints, mask sides before applying sealant and remove tape before sealant skins.
• Larger, heavier items need to be supported until the adhesive cures.
• Paint with water-based paint. A minimum of two coats are necessary to ensure proper wetting out the sealant surface
• The cure rate of the product is approximately 3-4mm in 24 hours. In most applications, a full cure is achieved after 3 days, depending on the thickness of the bead and weather conditions.

• Uncured product may be removed with mineral turps.
• Cured product can be removed by scraping or sanding or with the help of Selleys Silicone Remover.