Undo Glue Hook & Gel

HOOKS

• Apply the adhesive along the marked application lines on the back of the hook.

• Use an amount of adhesive appropriate to the size of the hook.

• Position the hook against the intended surface and apply firm, even pressure for approximately 30 seconds to ensure adequate contact.

• Allow the adhesive to cure fully before applying any load.

• Refer to the Load Capacity table for the relevant hook size

LIGHTWEIGHT MOUNTABLE MATERIALS

• Apply the adhesive in dots approximately 10-15 mm in diameter, positioned about 30 mm from the edge of the material

  - 2 dots for approximately A4-size or smaller

  - 4 dots for approximately A3-size

  - 6 dots for approximately A2-size

• Position the material on the desired surface and apply firm, even pressure for approximately 30 seconds to ensure good contact.

• Allow the adhesive to fully cure before use.

  Undo

• Grip or hold the edges of the hook or the attached item and firmly twist it anticlockwise to remove.

• Never pull towards you, as this may damage the wall or surface.

• Peel any residue from both the surface and the hook/item, then clean as necessary.

Notes:

As a guide, to facilitate clean removal, allow the adhesive to fully cure prior to removal. Under typical conditions, the product may remain adhered to porous substrates for up to 3 days and to non-porous substrates for up to 5 days before removal. For any remaining adhesive on textured surfaces, we recommend using Selleys Sealant Remover for easy clean-up.

Surface

• Ensure all bonding surfaces are clean, structurally sound, and free from dust, oil, rust, or any other contaminants. The product is suitable for use on both dry and damp surfaces.

• For non-porous substrates, clean the surface using a clean cloth lightly moistened with IPA or white spirit. Wipe in a single direction only, then immediately follow with a clean, dry cloth to remove any remaining residue.

Tube

• Remove the cap and use the reverse end of the cap to carefully pierce the seal on the tube.

• Squeeze the tube from the base to dispense the product.

• Once the desired amount has been dispensed, replace the cap securely.

• Retain the packaging for future reference and use.

Storage

• Store unopened packaging below 25 °C in a cool, dry place away from direct sunlight.

• Long-term exposure to elevated temperature can decrease material mechanical performance.

• Unopened packaging is best used within 12 months from the date of manufacture.