Point Works
Features
- Forms an incredibly strong and durable bond between the tiles and the ridge.
- Passes fatigue loading conditions of Cyclonic Conditions (C3 & C4) as per Australian Standard AS2050-2018
- Tested in accordance with AS4046.8-2015
- Flexes with normal roof movement without cracking or breaking away
- Sag resistant
- Smooth formula makes it easy to mix and apply
- Ideal for new roofs and roof repairs
Important Information
- Do not apply in wet conditions or if rain is expected within 12 hours
- Ensure adequate ventilation during use
- Use Selleys Point Works Accelerant Spray for faster curing
Downloads
- Technical Details
- Limitations
- Directions For Use
Technology |
Polyurethane Construction Adhesive Sealant |
Skin Time |
30 minutes |
Cure Time |
24 hours (depending on conditions) |
Movement Capability |
+/- 25% |
Paintability |
Yes (after curing) |
Mould and UV Resistance |
Yes |
Application Temperature Range |
5°C to 35°C |
Service Temperature |
-20°C to 80°C |
Suitable Substrates |
Metal Masonry Brick Concrete Tiles Timber |
Clean Up |
Solvent or mineral turps before cure |
- Not suitable for application on wet or frozen surfaces
- Avoid application if rain is imminent
- The following should only be used as a guide and the installer
should apply all Australian Standards, BCA/NZBC requirements,
and best practices when pointing roofs with Point Works Gen III. - Trowel Selleys Point Works Gen III to a thickness of 3 to 5 mm,
ensuring that pointing has full contact with the roof tiles and
under the edge of the hip/ridge tiles. Trowel in small runs to
ensure a neat and clean finish. Sweep down each hip and ridge
as pointing is complete to prevent excess product adhering to
tiles. - Use a wet trowel to get a smooth finish. Regularly clean the
trowel with water. Do not brush or sponge Selleys Point Works
Gen III as this will damage the finished appearance. - In case of cold and damp conditions, use Pointworks Accelerant
spray to speed up the drying. - Install weepholes in the pointing and the bedding mortar.
Weepholes may be put in as you go or on completion of the job. - Regularly mix the product in the bucket to avoid skinning. If the
product is left open for any period and a crust has formed,
discard the dried crust material. The material below will be
satisfactory. - Keep unused Selleys Point Works Gen III closely covered with
the plastic sheet inside the bucket and replace lid firmly. On reopening, remove plastic sheet and any skin formed around the
edges, mix and use as normal. Before use, Selleys Point Works
Gen III may be stirred to attain the desired trowelling
consistency. Never add water to restore trowelling ability. - If mixing colour into Selleys Point Works Gen III, place the colour
as deep as possible into the centre of the bucket. Mix with a
power-driven mixing wand at low speed until the colour becomes
consistent throughout.
Share
Share this Product with your friends